How to change the battery in your Clever Logger
Step 1. Buy a new battery
Step 2. Remove the sticker
Use a flat blade to lift up a corner of the sticker.
Peel it off and set it aside carefully, sticky side up, so that it can be re-used.
Step 3. Remove the four screws
Step 4 Remove circuit board
Carefully take out the circuit board. Try not to touch any components.
Step 5. Replace the battery
Slide the old battery out of the slot. It may help to carefully push it from the other side with the screwdriver.
Pay attention to which way up it should be.
Dispose of the old battery thoughtfully.
Pop the new battery into the slot.
Step 6. Replace circuit board
Place the board back into the casing.
It only goes in one way. Do not force it.
Step 7. Close the casing
Close the casing and replace the screws.
Step 8. Replace the sticker
If the sticker is damaged, call us and we can send you a replacement.
(There is an extra label included in the replacement battery kit.)
How to change the battery in your Temp & Humidity Logger (CLH)
If you have a Temperature and Humidity Clever Logger (CLH-01), please see these instructions below on how to change the battery.