Starting a CLH-01 Logger
Start your logger
The logger is switched off when you get it
Loggers have a raised power button on the front.
To start the logger, press and hold the power button for approximately 5 seconds until the IN USE light comes on. Release the power button.
The IN USE light will not stay on.
To check that the logger is running, keep watching the IN USE light. It will flash briefly every 10 seconds when the logger is recording. It can be quite hard to see unless you are looking at the logger straight on.
Turning the logger off
Press and hold the power button for 5-6 seconds again.
The IN USE light will flash 5 times. This indicates that the logger has turned off.
This will cause an offline alarm, so you will want to disable the alarm in the dashboard if you are planning this.
